Posted on

how to plant weed seeds in a pot

How to plant weed seeds in a pot

We see best results with seedling pellets that are made of a mix of compressed peat moss and coco husk. To expand, soak it in water for 10 to 15 minutes. Using warmer, lukewarm water, instead of cold water, will speed up the time the pellet takes to fully expand. Once your seedling pellet has absorbed enough water and has expanded to its maximum size, gently squeeze to remove excess water. The growing medium should be like a damp sponge that would not leave streaks on the table. Dig a small hole about 1/4 inch deep for your seed. Use a spoon to lift the seed out of its bath. If it has popped out a taproot be careful not to damage it. Gently place the seed into the hole and lightly cover it with dirt from the pellet. Now that you have started the germination process, your seedling will come above ground within two weeks. The older the seed, the longer it takes for it to germinate.

weed seed germination

To accelerate germination, soak your seed in a small container with lukewarm water and place it in a dark and warm place (like a kitchen cabinet) for 12-24 hours, but no longer. By drenching the seed, it absorbs the water thoroughly, activating the germination process on a physical and chemical level. Doing this helps to loosen the shell as it becomes a little softer making it easier for the embryo to crack it open. When your seed sinks to the bottom, it is ready to be planted, and sometimes the seed will pop out a small taproot. A seed can still be planted though if it does not sink or put out a taproot. When a seed pops a taproot (often called a tail), it becomes more vulnerable and it is better to plant it before this root emerges.

1) Germinating Your Cannabis Seed

Marijuana seedlings require a medium amount of light — enough to get energy to grow, but not too much light that to get burned. Leaving your seedling in direct sunlight will cause the leaves to curl, while too little light will cause the seedling to stretch. If growing outside, seedlings want to see a direct light source to stop them stretching. If inside, a sunny windowsill with more than half a day of sunlight works wonders. Otherwise, 24 to 30 inches from a grow light is an excellent supplement. Your seedling should not stretch more than 6 inches at most.

How to plant weed seeds in a pot

This article has been viewed 1,196,167 times.

How to Grow Basil Cuttings (Quick and Budget-Friendly Steps to Start Your Herb Garden)

wikiHow marks an article as reader-approved once it receives enough positive feedback. In this case, 94% of readers who voted found the article helpful, earning it our reader-approved status.

You Might Also Like

This article was co-authored by wikiHow Staff. Our trained team of editors and researchers validate articles for accuracy and comprehensiveness. wikiHow’s Content Management Team carefully monitors the work from our editorial staff to ensure that each article is backed by trusted research and meets our high quality standards.

Growing cannabis at home can be a fun project and a nice way to have your own cannabis plants on hand. You may want to grow cannabis indoors due to inclement weather in your area or due to a lack of green space in your yard. Start by germinating the seeds. Then, plant the seeds in soil or in a starter cube. Once the seeds have been planted, care for them properly so they grow and thrive.

About This Article

To plant cannabis seeds indoors, first soak the seeds in lukewarm tap water for 12 hours. Discard any seeds that float to the top. Then, place the seeds on a damp paper towel on a plate with 1 inch (2.5 cm) of space between each seed. Cover the seeds with another damp paper towel. Keep the seeds in a spot that remains between 70-80°F (21-27°C), and spray the paper towels with water whenever they start to dry out. The seeds will sprout in 2-3 days. When they do, fill pots or a growing tray 3/4 of the way with loose potting soil that has a pH between 5.8 and 6.3. Press the soil down lightly, leaving some air in it. Then, use a pencil to poke 1 inch (2.5 cm) holes in the soil. Place the sprouted seeds vertically in the holes and fill the holes with potting soil. Water the soil thoroughly and place the pots or tray in a spot that’s always 75°F (24°C) or warmer. Set up a grow light over the seeds and leave it on at all times. Water the seeds every day so the soil doesn’t dry out. The seedlings will emerge in 2-4 weeks. To learn how to use cool white grow lights to help your cannabis seeds grow, keep reading!